Until recently, golfers looking to hit higher shots would open the club face for more bounce and close the club face for lower shots. Numbered irons look identical and traditionally the pitching wedge has a similar straight edge. The angle created between these two points and the ground when the wedge is held upright and in the address position is known as the “bounce.” You can see the grind of an iron by looking at the back of the club. The second area of wedge fitting is the “grind.” In technical terms, grind is the angle between the leading edge of the club face (the part that strikes the ground first) and the lowest point on the sole (the bottom of the club face).
CALLAWAY ROGUE APPROACH WEDGE LOFT FULL
A wedge fitting will identify the lofts that work best for your wedge distances, so you can approach your scoring shots with more full swings and more confidence. The upshot is that less-skilled golfers are left with intimidating half-wedges and three-quarter wedge shots when playing in the so-called “scoring zone.” To fill in that gaping yardage club manufacturers offer wedges from 46 degrees of loft to 64. For shots between 40 and 120 yards, however, most golfers are left to choose between only a wedge and a sand wedge.
The first is “gapping.” Iron selection in golf between 120 and 200 yards is roughly calibrated by increments of 10-12 yards. There are two main areas of investigation in wedge fitting. With that in mind, getting fitted for the proper wedges for your game can be one of the most effective ways to lower scores. It is not unusual during some amateur rounds for the wedge to be the most-used club in the bag that is not the putter. Weekend golfers hit far fewer greens and will call on their wedge game much more often. Depending on that week’s course a pro will carry three or four wedges in his or her complement of 14 clubs. That leaves plenty of work for the short game. In an average round, a PGA Tour professional will hit about 12 greens.
0 kommentar(er)
